D-Link DGS-1510 Series Web Ui Reference Manual page 274

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
IP Precedence
ToS
DSCP
VID
CoS
Time Range
After selecting the Protocol ID option as the Protocol Type, the following page and parameters will be
available, as shown below:
Figure 8-99 Extended Expert ACL (Add Rule) Protocol ID window
The dynamic fields that can be configured are described below:
Parameter
Protocol
Fragments
MAC address here. When the MAC option is selected, the Wildcard
option will also be available. Enter the destination MAC address and
wildcard value in the spaces provided.
Select the IP precedence value used here. Options to choose from are
0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flash-override),
5 (critical), 6 (internet), and 7 (network).
After selecting the IP precedence value, select the Type-of-Service
(ToS) value that will be used here. Options to choose from are 0
(normal), 1 (min-monetary-cost), 2 (max-reliability), 3, 4 (max-
throughput), 5, 6, 7, 8 (min-delay), 9, 10, 11, 12, 13, 14, and 15.
Select or enter the DSCP value used here. This value must be
between 0 and 63.
Enter the VLAN ID that will be associated with this ACL rule here. This
value must be between 1 and 4094.
Select the Class of Service (CoS) value here. Options to choose from
are from 0 to 7.
Enter the name of the time range to associate with this ACL rule.
Description
Enter the Protocol ID value used here. This value must be between 0
and 255.
Select the Fragments option to include packet fragment filtering.
266