D-Link DGS-1510 Series Web Ui Reference Manual page 257

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
DSCP
TCP Flag
VID
CoS
Time Range
After selecting the UDP option as the Protocol Type, the following page and parameters will be available,
as shown below:
The dynamic fields that can be configured are described below:
Parameter
Source IP Address
Select or enter the DSCP value used here. This value must be
between 0 and 63.
Tick the appropriate TCP flag option to include the flag in this rule.
Options to choose from are ack, fin, psh, rst, syn, and urg.
Enter the VLAN ID that will be associated with this ACL rule here. This
value must be between 1 and 4094.
Select the Class of Service (CoS) value here. Options to choose from
are from 0 to 7.
Enter the name of the time range to associate with this ACL rule.
Figure 8-88 Extended Expert ACL (Add Rule) UDP window
Description
Select and enter the source information here. Options to choose from
are Any, Host, and IP. When the Any option is selected, any source
traffic will be evaluated according to the conditions of this rule. When
the Host option is selected, enter the source host's IP address here.
When the IP option is selected, the Wildcard option will also be
available. Enter the group of source IP addresses by using a wildcard
bitmap. The bit corresponding to the bit value 1 will be ignored. The bit
corresponding to the bit value 0 will be checked.
249