D-Link DGS-1510 Series Web Ui Reference Manual page 230

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
Destination
IP Precedence
ToS
DSCP
Time Range
After selecting the Protocol ID option as the Protocol Type, the following page and parameters will be
available, as shown below:
Figure 8-53 Extended IP ACL (Add Rule) Protocol ID window
The dynamic fields that can be configured are described below:
Parameter
Protocol
Fragments
Source
bitmap. The bit corresponding to the bit value 1 will be ignored. The bit
corresponding to the bit value 0 will be checked.
Select and enter the destination information here. Options to choose
from are Any, Host, and IP. When the Any option is selected, any
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host's IP
address here. When the IP option is selected, the Wildcard option will
also be available. Enter the group of destination IP addresses by using
a wildcard bitmap. The bit corresponding to the bit value 1 will be
ignored. The bit corresponding to the bit value 0 will be checked.
Select the IP precedence value used here. Options to choose from are
0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flash-override),
5 (critical), 6 (internet), and 7 (network).
After selecting the IP precedence value, select the Type-of-Service
(ToS) value that will be used here. Options to choose from are 0
(normal), 1 (min-monetary-cost), 2 (max-reliability), 3, 4 (max-
throughput), 5, 6, 7, 8 (min-delay), 9, 10, 11, 12, 13, 14, and 15.
Select or enter the DSCP value used here. This value must be
between 0 and 63.
Enter the name of the time range to associate with this ACL rule.
Description
Enter the Protocol ID value in the space provided. This value must be
between 0 and 255.
Select the Fragments option to include packet fragment filtering.
Select and enter the source information here. Options to choose from
are Any, Host, and IP. When the Any option is selected, any source
traffic will be evaluated according to the conditions of this rule. When
222