D-Link DGS-1510 Series Web Ui Reference Manual page 242

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
DSCP
Flow Label
Time Range
After selecting the ICMP option as the Protocol Type, the following page and parameters will be
available, as shown below:
The dynamic fields that can be configured are described below:
Parameter
Source
Destination
from are =, >, <, ≠, and Range. When selecting the = option, the
specific selected port number will be used. When selecting the >
option, all ports greater than the selected port, will be used. When
selecting the < option, all ports smaller than the selected port, will be
used. When selecting the ≠ option, all ports, excluding the selected
port, will be used. When selecting the Range option, the start port
number and end port number selected, of the range, will be used.
Alternatively, the port number(s) can manually be entered in the
space(s) provided, if the port number(s) is/are not available in the
drop-down list.
Select or enter the DSCP value used here. This value must be
between 0 and 63.
Enter the flow label value here. This value must be between 0 and
1048575.
Enter the name of the time range to associate with this ACL rule.
Figure 8-69 Extended IPv6 ACL (Add Rule) ICMP window
Description
Select and enter the source information here. Options to choose from
are Any, Host, and IPv6. When the Any option is selected, any source
traffic will be evaluated according to the conditions of this rule. When
the Host option is selected, enter the source host's IPv6 address here.
When the IPv6 option is selected, the Prefix Length option will also be
available. Enter the source IPv6 address and prefix length value in the
spaces provided.
Select and enter the destination information here. Options to choose
from are Any, Host, and IPv6. When the Any option is selected, any
234