D-Link DGS-1510 Series Web Ui Reference Manual page 239

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
Sequence No.
Action
Protocol Type
After selecting the TCP option as the Protocol Type, the following page and parameters will be available,
as shown below:
The dynamic fields that can be configured are described below:
Parameter
Source
Destination
Enter the ACL rule number here. This value must be between 1 and
65535. If this value is not specified, the system will automatically
generate an ACL rule number for this entry.
Select the action that this rule will take here. Options to choose from
are Permit and Deny.
Select the protocol type option here. Options to choose from are TCP,
UDP, ICMP, Protocol ID, ESP, PCP, SCTP, and None.
Figure 8-67 Extended IPv6 ACL (Add Rule) TCP window
Description
Select and enter the source information here. Options to choose from
are Any, Host, and IPv6. When the Any option is selected, any source
traffic will be evaluated according to the conditions of this rule. When
the Host option is selected, enter the source host's IPv6 address here.
When the IPv6 option is selected, the Prefix Length option will also be
available. Enter the source IPv6 address and prefix length value in the
spaces provided.
Select and enter the destination information here. Options to choose
from are Any, Host, and IPv6. When the Any option is selected, any
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host's
IPv6 address here. When the IPv6 option is selected, the Prefix
Length option will also be available. Enter the destination IPv6
address and prefix length value in the spaces provided.
231