D-Link DGS-1510 Series Web Ui Reference Manual page 181

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
Figure 8-6 ACL Configuration Wizard (Add Rule for IPv4 ACL) TCP window
The dynamic fields that can be configured are described below:
Parameter
Source
Destination
Source Port
Description
Select and enter the source information here. Options to choose from
are Any, Host, and IP. When the Any option is selected, any source
traffic will be evaluated according to the conditions of this rule. When
the Host option is selected, enter the source host's IP address here.
When the IP option is selected, the Wildcard option will also be
available. Enter the group of source IP addresses by using a wildcard
bitmap. The bit corresponding to the bit value 1 will be ignored. The bit
corresponding to the bit value 0 will be checked.
Select and enter the destination information here. Options to choose
from are Any, Host, and IP. When the Any option is selected, any
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host's IP
address here. When the IP option is selected, the Wildcard option will
also be available. Enter the group of destination IP addresses by using
a wildcard bitmap. The bit corresponding to the bit value 1 will be
ignored. The bit corresponding to the bit value 0 will be checked.
Select and enter the source port value here. Options to choose from
are =, >, <, ≠, and Range. When selecting the = option, the specific
selected port number will be used. When selecting the > option, all
ports greater than the selected port, will be used. When selecting the <
option, all ports smaller than the selected port, will be used. When
selecting the ≠ option, all ports, excluding the selected port, will be
used. When selecting the Range option, the start port number and end
port number selected, of the range, will be used. Alternatively, the port
number(s) can manually be entered in the space(s) provided, if the
173