D-Link DGS-1510 Series Web Ui Reference Manual page 323

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
Target Port
Unit
From Port / To Port
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specified entry.
IPv6 Source Guard
IPv6 Source Guard Settings
This window is used to view and configure the IPv6 source guard settings.
To view the following window, click Security > IMPB > IPv6 > IPv6 Source Guard > IPv6 Source Guard
Settings, as shown below:
The fields that can be configured are described below:
Parameter
Policy Name
Global Auto-Configure
Address
Link Local Traffic
Target Port
Unit
From Port / To Port
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specified entry.
Tick this option to specify the target port.
Select the switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Figure 9-57 IPv6 Source Guard Settings window
Description
Enter the policy name here. This name can be up to 32 characters
long.
Select to permit of deny data traffic from the auto-configured global
address. It is useful when all global addresses on a link are assigned
by DHCP and the administrator that wants to block hosts with self-
configured addresses from sending traffic.
Select to permit of deny hardware permitted data traffic send by the
link-local address.
Tick this option to specify the target port.
Select the switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
315