D-Link DGS-1510 Series Web Ui Reference Manual page 314

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
Trust State
Click the Apply button to accept the changes made.
Click the Set to Default button to change the information to the default values.
ARP Inspection VLAN
This window is used to view and configure the ARP inspection VLAN settings.
To view the following window, click Security > IMPB > IPv4 > Dynamic ARP Inspection > ARP
Inspection VLAN, as shown below:
The fields that can be configured are described below:
Parameter
VID List
State
Click the Apply button to accept the changes made.
ARP Inspection Statistics
This window is used to view and clear the ARP inspection statistics information.
To view the following window, click Security > IMPB > IPv4 > Dynamic ARP Inspection > ARP
Inspection Statistics, as shown below:
The fields that can be configured are described below:
Parameter
VID List
Click the Clear by VLAN button to clear the information based on the VLAN ID(s) entered.
Click the Clear All button to clear all the information in this table.
15. Tick the None option to disable the option.
Select to enable or disable the trust state here.
Figure 9-45 ARP Inspection VLAN window
Description
Enter the VLAN ID list used here.
Select to enable or disable the ARP inspection option's state for the
specified VLAN here.
Figure 9-46 ARP Inspection Statistics window
Description
Enter the VLAN ID list used here.
306