D-Link DGS-1510 Series Web Ui Reference Manual page 123

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Minimum Version
Fast Leave
Report Suppression
Suppression Time
Querier State
Query Version
Query Interval
Max Response Time
Robustness Value
Last Member Query Interval
Proxy Reporting
Source Address
Click the Apply button to accept the changes made.
IGMP Snooping Groups Settings
This window is used to configure and view the IGMP snooping static group, and view IGMP snooping
group.
To view the following window, click L2 Features > L2 Multicast Control > IGMP Snooping > IGMP
Snooping Groups Settings, as shown below:
Description
Select the minimum version of IGMP hosts that is allowed on the
VLAN.
Select this option to enable or disable the IGMP snooping fast leave
function. If enabled, the membership is immediately removed when the
system receive the IGMP leave message.
Select this option to enable or disable the report suppression. The
report suppression function only works for IGMPv1 and IGMPv2 traffic.
When report suppression is enabled, the Switch suppresses the
duplicate reports sent by hosts. The suppression for the same group
report or leave will continue until the suppression time expired. For
report or leave messages to the same group, only one report or leave
message is forwarded. The remaining report and leave messages are
suppressed.
Enter the interval of suppressing duplicate IGMP reports or leaves.
The range is from 1 to 300.
Select this option to enable or disable the querier state.
Select the general query packet version sent by the IGMP snooping
querier. Options to choose from are 1, 2, and 3.
Enter the interval at which the IGMP snooping querier sends IGMP
general query messages periodically.
Enter the maximum response time, in seconds, advertised in IGMP
snooping queries. The range is 1 to 25.
Enter the robustness variable used in IGMP snooping.
Enter the interval at which the IGMP snooping querier sends IGMP
group-specific or group-source-specific (channel) query messages.
Select this option to enable or disable the proxy-reporting function.
Enter the source IP of proxy reporting. This is available when Enabled
is selected in Proxy Reporting.
115