D-Link DGS-1510 Series Web Ui Reference Manual page 124

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
The fields that can be configured for IGMP Snooping Static Groups Settings are described below:
Parameter
VID
Group Address
Unit
From Port / To Port
VID
Group Address
Click the Apply button to accept the changes made.
Click the Delete button to remove the specified entry.
Click the Find button to locate a specific entry based on the information entered.
Click the Find All button to view all the entries.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
The fields that can be configured for IGMP Snooping Groups Table are described below:
Parameter
VID
Group Address
Click the Find button to locate a specific entry based on the information entered.
Click the Find All button to view all the entries.
IGMP Snooping Mrouter Settings
This window is used to configure the specified interface(s) as the multicast router ports or as forbidden to
be multicast router ports on the Switch.
Figure 5-40 IGMP Snooping Groups Settings
Description
Enter a VLAN ID of the multicast group.
Enter an IP multicast group address.
Select the switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Click the radio button and enter a VLAN ID of the multicast group.
Click the radio button and enter an IP multicast group address.
Description
Click the radio button and enter a VLAN ID of the multicast group.
Click the radio button and enter an IP multicast group address.
116