D-Link DGS-1510 Series Web Ui Reference Manual page 130

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
Report Suppression
Suppression Time
Proxy Reporting
Source Address
Mrouter Port Learning
Querier State
Query Version
Query Interval
Max Response Time
Robustness Value
Last Listener Query Interval
Click the Apply button to accept the changes made.
MLD Snooping Groups Settings
This window is used to configure and view the MLD snooping static group, and view MLD snooping group.
To view the following window, click L2 Features > L2 Multicast Control > MLD Snooping > MLD
Snooping Groups Settings, as shown below:
The fields that can be configured for MLD Snooping Static Groups Settings are described below:
Parameter
VID
Select this option to enable or disable the report suppression.
Enter the interval of suppressing duplicate MLD reports or leaves. The
range is from 1 to 300.
Select this option to enable or disable the proxy-reporting function.
Enter the source IP of proxy reporting. This is available when Enabled
is selected in Proxy Reporting.
Select this option to enable or disable Mrouter port learning.
Select this option to enable or disable the querier state.
Select the general query packet version sent by the MLD snooping
querier. Options to choose from are 1, and 2.
Enter the interval at which the MLD snooping querier sends MLD
general query messages periodically.
Enter the maximum response time, in seconds, advertised in MLD
snooping queries. The range is 1 to 25.
Enter the robustness variable used in MLD snooping.
Enter the interval at which the MLD snooping querier sends MLD
group-specific or group-source-specific (channel) query messages.
Figure 5-46 MLD Snooping Group Settings window
Description
Enter a VLAN ID of the multicast group.
122