D-Link DGS-1510 Series Web Ui Reference Manual page 185

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
After selecting the ICMP option as the Protocol Type, the following section will appear.
Figure 8-8 ACL Configuration Wizard (Add Rule for IPv4 ACL) ICMP window
The dynamic fields that can be configured are described below:
Parameter
Source
Destination
Specify ICMP Message Type
ICMP Message Type
Message Code
Description
Select and enter the source information here. Options to choose from
are Any, Host, and IP. When the Any option is selected, any source
traffic will be evaluated according to the conditions of this rule. When
the Host option is selected, enter the source host's IP address here.
When the IP option is selected, the Wildcard option will also be
available. Enter the group of source IP addresses by using a wildcard
bitmap. The bit corresponding to the bit value 1 will be ignored. The bit
corresponding to the bit value 0 will be checked.
Select and enter the destination information here. Options to choose
from are Any, Host, and IP. When the Any option is selected, any
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host's IP
address here. When the IP option is selected, the Wildcard option will
also be available. Enter the group of destination IP addresses by using
a wildcard bitmap. The bit corresponding to the bit value 1 will be
ignored. The bit corresponding to the bit value 0 will be checked.
Select the ICMP message type used here.
When the ICMP Message Type is not selected, enter the ICMP
Message Type numerical value used here. When the ICMP Message
Type is selected, this numerical value will automatically be entered.
When the ICMP Message Type is not selected, enter the Message
Code numerical value used here. When the ICMP Message Type is
selected, this numerical value will automatically be entered.
177