D-Link DGS-1510 Series Web Ui Reference Manual page 213

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Sequence No.
Action
Source
Destination
Time Range
Click the Back button to discard the changes made and return to the previous page.
Click the Apply button to accept the changes made.
To enable the Counter State option or to enter a Remark for the profile, click the Edit button, next to the
specific ACL profile (found in the ACL profile table).
The fields that can be configured are described below:
Parameter
Start Sequence No.
Step
Counter State
Description
Enter the ACL rule number here. This value must be between 1 and
65535. If this value is not specified, the system will automatically
generate an ACL rule number for this entry.
Select the action that this rule will take here. Options to choose from
are Permit and Deny.
Select and enter the source information here. Options to choose from
are Any, Host, and IP. When the Any option is selected, any source
traffic will be evaluated according to the conditions of this rule. When
the Host option is selected, enter the source host's IP address here.
When the IP option is selected, the Wildcard option will also be
available. Enter the group of source IP addresses by using a wildcard
bitmap. The bit corresponding to the bit value 1 will be ignored. The bit
corresponding to the bit value 0 will be checked.
Select and enter the destination information here. Options to choose
from are Any, Host, and IP. When the Any option is selected, any
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host's IP
address here. When the IP option is selected, the Wildcard option will
also be available. Enter the group of destination IP addresses by using
a wildcard bitmap. The bit corresponding to the bit value 1 will be
ignored. The bit corresponding to the bit value 0 will be checked.
Enter the name of the time range to associate with this ACL rule.
Figure 8-35 Standard IP ACL (Edit ACL) window
Description
Enter the start sequence number here.
Enter the sequence number increment here.
Select to enable or disable the counter state option here.
205