D-Link DGS-1510 Series Web Ui Reference Manual page 203

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
Destination Port
DSCP
Flow Label
Time Range
Action
After selecting the ICMP option as the Protocol Type, the following section will appear.
Figure 8-23 ACL Configuration Wizard (Add Rule for IPv6 ACL) ICMP window
The dynamic fields that can be configured are described below:
number(s) can manually be entered in the space(s) provided, if the
port number(s) is/are not available in the drop-down list.
Select and enter the destination port value here. Options to choose
from are =, >, <, ≠, and Range. When selecting the = option, the
specific selected port number will be used. When selecting the >
option, all ports greater than the selected port, will be used. When
selecting the < option, all ports smaller than the selected port, will be
used. When selecting the ≠ option, all ports, excluding the selected
port, will be used. When selecting the Range option, the start port
number and end port number selected, of the range, will be used.
Alternatively, the port number(s) can manually be entered in the
space(s) provided, if the port number(s) is/are not available in the
drop-down list.
Select or enter the DSCP value used here. This value must be
between 0 and 63.
Enter the flow label value here. This value must be between 0 and
1048575.
Enter the name of the time range to associate with this ACL rule.
Select the action that this rule will take here. Options to choose from
are Permit and Deny.
195