Tti Select; Automatic Document Size Detection; Select Scanning Size To Be Sent - Muratec MFX-2530 Operating Instructions Manual

Basic fax

TTI select

When you send a fax message, your TTI is automatically printed at the top of docu-
ments you send. You can select one of three TTI you've stored in your machine.
Note: See "EasyStart" on pages 1.17–1.18, to refer the storing the TTI.
To select the TTI:
1
Place the document and select resolution and contrast you require.
2
Press until [TTI] is appeared on the
NEXT
3
Press [TTI].
4
Using a cursor key to select TTI you want to
send.
5
Press [Enter].
6
Dial a fax number.
7
Press .
START
Note: After transmission if you did not select TTI before sending a document, the
stored TTI you've selected in EasyStart will be printed at the top of docu-
ment you send.

Automatic document size detection

Your machine can automatically detect the following size of your document.
• Letter (8.5" × 11")
• Legal (8.5" × 14")
• Ledger (11" × 17")
• Half-letter (5.5" × 8.5")
Note: Half-letter is available only with the
If you set the non-standard sized document or the machine could not detect the doc-
ument size, select the scanning size manually. (See the right column.)
3.2
All manuals and user guides at all-guides.com
TTI
Use cursor to select
.
TTI.
LCD
1:AABBCC
2:BBCCDD
3:CCDDEE
.
FBS

Select scanning size to be sent

When you send or store your document, usually
the size of your document when it is placed on th
wish to override this and select scanning size ma
steps.
Note: You can select one of the following stand
•Letter(8.5" × 11")
•Half-letter(5.5" × 8.5")
•Legal(8.5" × 14")
•Ledger(11" × 17")
* : Half-letter
Note: If you want to set the different sized doc
Mix Length feature on. (See page 3.33.)
Note: To override auto document size detection
Enter
at each page scanning.
To select the scanning size manually:
1
Place the document and select resolution a
2
Enter
NEXT
3
Select desired size by using a cursor key.
Note: When you use the
4
Press [Enter].
5
Enter the fax number and press
*
is available only with th
, [ScanSize].
, "H.LTR" wi
ADF
shaded and cannot be selected.
START
.