Combine - Muratec MFX-2530 Operating Instructions Manual

Advanced Copy

Combine

You can copy 2, 4 or 8 pages of your documents into one sheet.
2 pages --> 1 sheet
8 pages --> 1 sheet
2
1
Note: If you select the 2 in 1 or 8 in 1, you should set your document with the dif-
ferent direction from the direction of recording paper you selected.
If you select the 4 in 1, you should set your document with the same direc-
tion from the direction of recording paper you selected.
Note: You can print a separator line between copied images.
Note: In this mode, the reduce/enlarge ratio will be set to "Auto" (automatically).
If you want to set the reduction/enlargement ratio manually, set the ratio
after setting the combine function.
Note: According to the size of document and recording paper you selected, a part
of the image might be lacked.
Note: If the number of the documents you set was less than document pages you
selected for combining, the last page(s) will be copied blank.
Note: The machine cannot copy your documents different in size and direction.
Make sure the document are set to same direction shown on the LCD.
Note: You cannot use this function with the duplex function.
2.10
All manuals and user guides at all-guides.com
4 pages --> 1 sheet
2 4
6 8
4 6 8
1 3 5 7
3 5 7
To copy with combining:
1
Press .
MENU
2
Select "Combine" using the cursor key, a
Note: The Auto Reduce/Enlarge is select
3
Select the desired combination modes usin
cursor key.
Note: The number of documents combin
can be 2, 4 or 8.
4
If you want to change the recording paper
for combining, proceed to next step. Other
skip to step 6.
5
Press [Paper] to select the paper size, an
6
You can insert the separator lines between
insert the separator lines, proceed to next
7
Press and then press [Line] to print
NEXT
separator lines. To cancel the separator li
press [Line] again.
Note: The width of the line can be chang
(See page 2.28.)
8
If you want to arrange the position of the e
document, proceed to next step. Otherwise
9
Press [Position], the
LCD
Note: If [Position] does not appear on t
, press
LCD NEXT
10
Select the position using the cursor key an
enter the number of the document you wa
change using the numeric keypad.
Note: The number which was on the pos
with the number you entered.
Note: If you want to reset to the initial p
11
Press [Enter] to save the setting.
will show:
.