Redialing; Canceling Commands - Muratec MFX-2530 Operating Instructions Manual

Basic fax

Redialing

If your fax call fails, your machine automatically redials it. In the Auto Redial mode,
your fax automatically redials the number every minute until one of the following hap-
pens:
• It reaches the remote fax machine.
• It has attempted the two redials and has still not connected.
While in the Auto Redial mode, the machine can continue to receive faxes and can
make as many as 100 fax transmissions.
Note: If you used either the speaker or a handset to dial, you must redial manu-
ally (see below).
Note: The default setting of redial attempts is as flowing:
Number of redials : 2 times
Redial interval : 1 minute.
You can change this setting as you want. See "Changing redial settings,"
page 3.75.
If the last redial attempt fails:
1
The will ask you if it should attempt the redials again:
LCD
2
If you want the machine to attempt it again,
press [Yes].
Otherwise, press [No]. Your machine will print
and display error messages.
Redialing manually
You can always redial calls manually. And you must redial manually if you use
either the monitor speaker or an optional handset to dial the failed call.
To redial a fax call manually without using the monitor speaker or an optional
handset:
1
Make sure the document is in the
are set.
2
Press [Redial],
START
3.6
All manuals and user guides at all-guides.com
987-6543
Yes
and that the resolution and contrast
ADF
.
All redials failed.
Try again?
Num. of redials :02
No
To redial a fax call manually with the monitor s
1
Make sure the document is in the
are set.
2
Press / or lift the optional ha
MONITOR CALL
3
Press [Redial].
4
When you hear fax tones from the remote u
Note: If a person answers the phone, use
person you're sending a fax. When
To redial a voice call manually using the optiona
1
Lift the optional handset to get a dial tone
2
Press [Redial]. When the other person an
speak to that person.

Canceling Commands

The Job Review function gives you the power to
your machine's memory. It also lets you cancel a
the document.
To cancel a command:
1
Press
JOB REVIEW COMM CANCEL
&
2
If your machine is attempting to perform
command now, it will appear on the displa
Skip to step 5.
Otherwise, proceed to step 3.
3
Select "Reserved Transmission" and th
press [Enter]. The list of Reserved Transm
will appear.
4
Select the command you want to cancel us
5
Press [Erase].
To return your machine to standby mode,
For more information on the Job Review functio
and
ADF
.