Muratec MFX-2530 Operating Instructions Manual page 116

Advanced fax
If you chose Relay:
28
The bulletin box has the following settings:
• Box Name – Same as in step 7.
• - sub-address – Same as in step 7.
ITU T
• - password – Same as in step 7.
ITU T
• Location – You must enter the fax number
of the remote unit. When your machine
received document into the relay box, it dials
to this number to relay the received docu-
ment.
• TTI Type – You can select the type of
you want to appear on the faxes that are
relayed to other callers.
• Auto Print – You can set your machine to
print the received document received into the relay box.
• . . code for this F-Code box – This is the four-digit
I D
box's security, which you use to enter before you can make any changes to
this F-Code box. (See step 35.)
29
To enter the Box name:
This is same procedure in step 8. Please refer to step 8.
30
To enter the -
ITU T
This is same procedure in step 9. Please refer to step 9.
31
To enter the -
ITU T
This is same procedure in step 10. Please refer to step 10.
32
To enter the Location:
Select "Location" using the cursor key, and
then press [Enter].
Then, enter the fax number using a one-touch
key, a speed-dial number or a call group num-
ber. You cannot use the numeric keypad to
enter these numbers.
To add each fax number, press [Broadcas] between each one to insert a
comma, then enter the number. You can specify up to 300 numbers for a
remote unit.
Press [Enter] to save the box's name and continue.
3.48
All manuals and user guides at all-guides.com
TTI
sub-address:
password:
01:Relay Box SetBox
Use cursor to select
item.
Box Name :
Sub-Address :
Password :
Location :
TTI Type :Sender
Exit Enter
01:Relay Box SetBox
Use cursor to select
item.
Auto Print :OFF
Exit Enter
. . code for the
I D
01:Relay Box SetBox
Enter remote fax number.
_
Group Clear Enter
33
To set the TTI Type:
Select "TTI Type" using the cursor key, a
Then, select the type of
to other callers.
• Sender — Relay the document with h
unit's (don't send your
TTI
• Both — Relay the document with both
hub unit's and your
TTI
• Yours — Relay the document with you
instead of the hub unit's.
Press [Enter] to save the box's name and
34
To set the Auto Print:
Select "Auto Print" using the cursor key,
Then, select desired setting "On" or "Off".
On: Print the document automatically w
Off: The machine does not print it, but on
Press [Enter] to save the box's name and
35
Press [Exit].
The machine asks for your F-Code box's fo
digit security . . code. This is the
I D
the box's security, which you use to enter b
you can make any changes to this F-Code
36
Decide on a four-digit .
I
this F-Code box.
Write it down, and put it in a safe place.
Important: Do not use 0000 as an
37
Use the numeric keypad to enter the four-
Important: After completing this step, y
this F-Code box. Be sure to
38
Press to save the F-Code box inform
ENTER
To create or modify another F-Code box, g
To finish, press .
RESET
you want to ap
TTI
).
TTI
.
TTI
. . code
I D
. code (0001-9999
D
. . co
I D