Some Guidelines; Resolution, Grayscale And Contrast - Muratec MFX-2530 Operating Instructions Manual

Some guidelines

Resolution, grayscale and contrast

Reviewing resolution and grayscale:
• Normal resolution is suitable for most typed documents and simple drawings.
• Fine resolution is ideal for maps, moderately complicated drawings, floorplans or
handwritten documents.
• Superfine resolution (" -
S FINE
extremely complicated drawings or line art.
• Grayscale mode ("
HALFTONE
shades in photos and drawings.
Note: If you send a fax in superfine, certain fax models (especially older, non-
Muratec models) receive it only in fine mode. However, you can send a fax in
grayscale mode to virtually any fax machine currently in use.
To change the resolution setting, press
A glowing
LED
that .
LED
Reviewing contrast:
Setting the contrast allows you to compensate for any excessive lightness or dark-
ness, as the case may be, of document pages you are sending or copying.
Pressing to select the contrast mode:
CONTRAST
– Darkens weak, "washed-out" images.
DARK
= – Provides some darkening of documents.
– Suited to most documents.
NORMAL
= – Provides some lightening of documents.
– Lightens up overly dark documents.
LIGHT
– This mode automatically set the suitable setting
AUTO
Note: You can set the primary mode of the resolution and contrast. (See page
3.69.)
All manuals and user guides at all-guides.com
" on the control panel) reproduces the detail of
" on the control panel; "Gray" on the
RESOLUTION
indicates the machine is using the setting named by
according to the document density.
Mixing resolution and contrast in a m
When you send the document with more than on
olutions and contrasts for each page.
Place your document, select resolution and cont
START
When the document is placed in the
Select resolution and contrast before the ne
) captures
LCD
When the document is placed on the
1
2
repeatedly.
Entering a pause character wh
Some long-distance systems require dialing pau
when you're dialing through special telephone e
When you are dialing or storing the autodialer, a
acter, press
[Pause] after you've dialed at least one other ch
will appear on the
Each pause entered lasts for a factory-set two se
For example, if the pause is at the factory settin
19725552009 dials 9 [2-second pause] 1 9 7 2 5 5
Note: Each pause uses two of the characters y
Note: To change the dialing pause length, see
. Then follow one of the following two proc
Remove the previous page and place the n
Select resolution and contrast. Then press
until the [Pause] is appeared
NEXT
.
LCD
page 3.75.
ADF
glas
FBS