Troubleshooting - Muratec MFX-2530 Operating Instructions Manual

Troubleshooting

Occasionally, your machine encounters some trouble transmitting or receiving docu-
ments. When it does, it alerts you with an alarm. You can identify the problem with
messages and printed check messages and error reports, explained in the follow-
LCD
ing pages.
Alarm
Your fax machine sounds an alarm tone — a series of short beeps — if either of
these two problems occur:
• Trouble transmitting or receiving
• The machine is out of paper
error messages
LCD
If a message not listed here is displayed, take corrective action by following the
instructions in the message.
< Copy >
What you see on the
LCD
ADF is not When use the series copy function, the document is set in
available. the
Set document Remove the document from
on FBS glass on
FBS
Auto doc. size Non-standard size document is set. Your machine can
detection failed. detect Letter
11"×17"(ledger
Pressing
paper. Or, press
the [Paper]. And then try again.
. . . or . . .
Document is not set. Set your document.
Check paper size The paper size setting is incorrect.
Check the paper size and set the proper paper size.
All manuals and user guides at all-guides.com
What it means/What to do
. You cannot use the for series copy.
ADF ADF
, then set the document
ADF
glass.
, Legal , Half-letter
) sized document only.
to copy your document to the auto selected
START
then select paper manually by using
STOP
Copy protected
Enter job hold time.
No paper size
is suitable.
OK to continue
copying?
No paper size
is suitable.
Copying with auto
selected paper.
Not enough memory
The last XXX page
was erased.
Please copy again.
Not available with
XXXX
Please call service
Not enough memory. The "Last Job" docum
and
Document was erased. memory shortage.
Rotate document
by 90° or set ratio
Set document in ADF In Booklet copy, you ca
Unable to set
ratio during
D.Mag. is used.
You tried to use your m
unit's copy protection
Turn off copy protectio
You tried to use the "L
hold time" has not bee
time". (See "Last Job H
Your machine does no
length copy. To continu
papers the shows.
LCD
other ratio.
There is no paper that
Press then select
STOP
The copying was stopp
Please copy again from
You have set two func
Cancel either one of th
The printer unit of yo
ble. Call your authoriz
Customer Support.
In combine, repeat, se
function, the documen
Set the document in th
reduce/enlarge ratio.
Set your document in
You cannot s
the direction