Maintenance; Maintaining And Changing A Camera With A Light - Omron V530-R160E User Manual

SECTION 10
Appendix

Maintenance

Maintaining and Changing a Camera with a Light

• The Light will gradually become dimmer as it is used (approx. 20% dimmer after 1,500 hours of
operation).
Replace the Light after approx. 1,500 hours of use.
• Replace the Light if it is partially damaged or not fully functioning.
 F150-SLC20 Maintenance
Light
 Removing the Light
1.
Disconnect the light cable from the light connector on the back of the Camera.
2.
Remove the light cable from the slot in the camera base.
3.
Remove the two screws that secure the Light.
4.
Remove the bottom two screws that secure the Light.
5.
Remove the Light from the Camera.
6.
Reverse the procedure 1 through 5 to install the Light.
Do not disassemble the Lens. Disassembly can damage the Lens.
When using the Camera alone without connecting an Intelligent Lighting (F150-S1A-2D):
The bottom two screws shown in
screws for the bottom screws instead.
The top screws shown in
V530-R160
264
Operation Manual
Field of vision
20 mm F150-LTC20
Camera base
2
1
Hold this section
when removing the Cable
4.
will be too long and won't fit the Camera. Use two M2 × 3
3.
are not needed.
Model
5
3
4
Light