Omron V530-R160E User Manual page 154

SECTION 6
Other Functions
1.
Connect the COM1 port on the computer and the V530-R160 using an RS-232C cable.
2.
Make the V530-R160 communications settings (serial).
The default communication settings are as shown in the following table. These settings can be normally
used.
Communications protocol
Baud rate
Data length
Parity bits
Stop bits
Protocol
* Both XMODEM and ZMODEM transfer protocols are supported. Use the protocol that matches the com-
puter settings.
3.
Start the Hyper Terminal program on the computer and make the following communication set-
tings.
The same communication settings must be used on both the V530-R160 and the modem on the computer.
Baud rate
Data bits
Parity bits
Stop bits
Flow control
* XMODEM or ZMODEM protocol is used, so flow control is not performed.
V530-R160
152
Operation Manual
Item
RS-232C
38400 (bps)
8 (bit)
None
1 (bit)
XMODEM*
Item
38400 (bps)
8 (bit)
None
1 (bit)
None*
Setting
p.206 (Sec. 8).
Setting