Omron V530-R160E User Manual page 91

Various commands can be input from a host device in addition to the trigger input.
Via the parallel I/O
Via the serial interface port using Normal communications
Via the serial interface port using Host Link communications
Reading judgements can be output to host devices via the serial interface.
Via the serial interface port using Normal communications
Via the serial interface port using Host Link communications
Read images can be stored.
Up to 35 images can be stored in memory. Once 35 images have been stored, the existing images
will be overwritten in order starting with the oldest.
Move to SYS/Image storing and change the conditions for image storage.
To store NG images only, select Only NG, and to store images regardless of the reading result,
select All.
Read images can also be backed up automatically to the Memory Card.
Turn ON SYS/ Image storing /Store to MemCard.
Refer to page 182 (Sec.7).
Reading can be repeated for stored images.
Display the desired stored image using the SHIFT + Up/Down Keys and press the SHIFT + TRIG
Keys to execute reading.
Reading can also be repeated for freeze images without re-inputting the image using the SHIFT +
TRIG Keys. By reading an image again after adjusting the reading conditions, you can check if the
conditions are appropriate.
The light will gradually become dimmer as it is used, so adjust the reading conditions periodically.
The light dims about 20% in 1500 hours of use. (Applies to Intelligent Lighting)
SECTION 4
Basic Operations
Refer to page 194 (Sec.8).
Refer to page 212 (Sec.8).
Refer to page 240 (Sec.8).
Refer to page 227 (Sec.8).
Refer to page 243 (Sec.8).
V530-R160
Operation Manual
89