Omron V530-R160E User Manual page 59

Wire
Pin Signal
color
A1 RESET Light
brown
A2 TRIG A Yellow
A3 TRIG B Green
A4 TRIG D Gray
−
A5 White
−
A6 Light
brown
−
A7 Yellow
−
A8 Green
A9 RUN Gray
A10 BUSY White
A11 OK/NG Light
brown
A12 DO0 Yellow
A13 DO2 Green
A14 DO4 Gray
A15 DO6 White
A16 DO8 Light
brown
A17 DO9 Yellow
A18 DO11 Green
A19 DO13 Gray
A20 ALARM White
Note: Pins A9 to A11 and B9 to B10 are for control signals.
Do not use RESET input immediately after power is turned ON. When using RESET input to syn-
chronize execution timing, wait at least 1 second after turning ON the V530-R160 power supply
before turning ON the RESET terminal.
Use DC power supplies with safe extra low-voltage circuits for COMIN in order to prevent high volt-
ages. If UL recognition is required, use a UL class II power supply.
Marking
Function
(Black)
Restarts the
V530-R160.
Trigger input
(One shot
reading)
Trigger input
(Continuous/
level trigger)
Trigger input
(Scene set-
ting, level trig-
ger)
Do not use.
ON while in
RUN mode
ON during
processing
Outputs read-
ing judge-
ments
Do not use.
ON when a
Trend Moni-
tor error
occurs.
Connection to the Host
Wire
Pin Signal
color
B1 COMIN Light
brown
B2 DSA Yellow
B3 TRIG C Green
−
B4 Gray
−
B5 White
−
B6 Light
brown
−
B7 Yellow
−
B8 Green
B9 ERROR Gray
B10 GATE White
B11 COMOUT1 Light
brown
B12 DO1 Yellow
B13 DO3 Green
B14 DO5 Gray
B15 DO7 White
B16 COMOUT2 Light
brown
B17 DO10 Yellow
B18 DO12 Green
B19 DO14 Gray
B20 COMOUT3 White
SECTION 3
Marking
Function
(Red)
Common for
input signals
Do not use.
Trigger input
(Scene setting,
level trigger)
Do not use.
ON when an
error has
occurred
ON for the set
output time
Common for
control signals
(See note.)
Do not use.
Common for
DO0 to DO7
Do not use.
Common for
DO9 to DO15
V530-R160
Operation Manual
57