Ricoh 2400L Operator's Manual page 833

AUTOMATICALLY PRINTED REPORTS
The following pages explain the symbols that appear in certain columns of the
reports.
The Mode Column
See the bottom of the JOURNAL for a full listening of the symbols that are used
on the JOURNAL.
The Results Column
OK: Successful Communication
E: An error occurred
The Footnote on the JOURNAL
TX counter: Total number of transmitted pages
RX counter: Total number of received pages
Counters listed on the User Parameter List
SCN: Total number of pages scanned
PRN: Total number of pages printed
Transmission Result Report (Memory Transmission)
In the Result column, some reports may have an "E" followed by a code, and
there may be a message printed at the bottom of the report. This code and
message indicate that a problem occurred. The codes are explained below.
CODE
1
HANG UP OR LINE FAIL
2 BUSY
3 NO ANSWER
4 NO FACSIMILE CONNECTION
142
MESSAGE EXPLANATION
The other party either a) hung up, b) had no
message on polling standby, c) cannot do
confidential reception or transfer request, or d)
had an ID Code that did not match the one in
your machine. Alternatively, there could have
been a problem with the telephone line.
The machine at the other end was busy.
The line is dead (no dial tone was detected).
The machine at the other is not a facsimile.
REPORTS