Ricoh 2400L Operator's Manual page 370

OTHER
Note:If you see ALREADY INPUT,you already have a message on Free Polling
F
Standby.
To clear the old message: Clear the old polling transmission file
by function 23. ( See page 159 .) And start from the step 1 again.
Secured Polling
1. Place your document in the feeder.
2. Function 1 4 and Yes.
NOTE
If you have not yet stored an ID Code using Function 61, you will be asked to
enter an ID Code. Proceed in the same way as for step 4 in "Stored ID
Override" on the next page.
3. Start
-Your fax message is stored and held on polling
standby.
Note:If you see
AL READY I NPUT
Polling Standby. F
To erase the old message: Clear the old polling transmission file
by function 23. ( See page 159 .)
F
To keep the old message: Input an ID code in the same way as
for step 3 in "Stored ID Override" below.
Stored ID Override
This procedure will override the ID Code stored in your machine. The override is
only effective for this one transmission.
1. Place your document in the feeder.
2. Function 1 4 and Yes.
k
3. Press until the screen is as shown op-
posite.
154
you already have a message on Secured
ADVANCED FEATURES
k
k
k
k
k