Ricoh 2400L Operator's Manual page 592

CHANGING THE PAPER SIZE
[Optional Paper Feed Cassette]
End fence
11
11
5. Change the paper size plate (located
at the front of the cassette).
To remove an existing plate , squeeze
the two vertical tabs slightly inwards while
pulling the plate out from below
(see diagram). insert a plate with the
appropriate paper size engraved on the front.
6. Fit the paper fence lock behind the rear
fence of main cassette as shown in the
diagram. The lock sholud fit into the
slots on the base of the tray and shold
be snung against the paper fence. Insert
the holding pin as shown and fix the
plastic nut, under the tray.
7. Fan the paper. Make sure the edge are
uniformly aligned and place the paper
in the cassette with the side on you wish
to print face up. Check the paper fits
under the metal corers.
If there is space between the paper and
a fences, the paper will not be fed
properly. To avoid this, carefully move
in each fence until it is flush with the paper.
NOTE: Do not fill up the cassette past the
load limit marker.
Load Limit
8. Replace the cassette carefully.
136
LOOKING AFTER THE MACHINE
Side fence
[Main Cassette]
[Optional Paper Feed Cassette]
8 1 2