Ricoh 2400L Operator's Manual page 629

TECHNICAL REFERENCE
Switch 09 - Various
Digit
Memory lock
(Feature Expander Required)
Locked messages are printed
0, 1 when you enter the memory
lock ID.
2 to 7 Do not change these settings.
Switch 10 Various
Digit
0 Reverse order printing (Feature Expander Required) 0: Off*
1 Two in One (Into 1)
2 to 6 Do not change these settings.
Halftone mode
7
Switch 11 Various
Digit
0 to 5 Do not change these settings.
Printing the received message when acting as a forwarding station.
6
7 Polling standby duration
Switch 12 Various
Digit
0 and 1 Do not change these settings.
Toner saving mode
Note:
If on, contrast will be set to "Normal" automatically, preserving image quality.
This is available when receiving fax messages and printing reports, but not for
copying or printing from a PC.
2 Further, messages sent to you in halftone mode will automatically turn off toner
saving to ensure a clear image.
To make sure that the fax quality is acceptable with toner saving on, print a few
reports (see page 123 ).
(Note: If the sender is using a machine made by another manufacturer, toner saving
will stay on and this could lower image quality.)
Density of the printing image
Digit 4 Digit 3 Setting
3 and 4 0
1
5 to 7 Do not change these settings.
Switch 13 - Do not use.
Digit 1 Digit 0 Setting
Digit 4 Digit 3 Setting
0 Normal * 0
0 Darken 1
ON/OFF SWITCHES AND USER PARAMETERS
Purpose
X 0 Off*
0 1 Only Lock messages from senders
whose RTI/CSI's are programmed.
1 1 Lock all messages except those from
senders whose RTI/CSI's are
programmed.
Purpose
0: Off*
0: Standard Mode*
1: Speed Mode
Purpose
0: Off
0: Once*
Purpose
0: Off*
1 Lighten
1 Do not use
this setting.
1: On
1: On
1: On*
1: Keep
1: On
173