Ricoh 2400L Operator's Manual page 867

OPERATING DIFFICULTIES
Transmission cannot take
place; CLEAR ORIGINAL
appears.
Transmission cannot take
place; the Line Fail indicator
blinks.
Note: Before taking action,
wait until the Communicating
indicator goes out, then press
the Stop key.
Consistent difficulty in
communicating with a
particular terminal
Consistent poor image quality
when communicating with a
particular terminal
RECEPTION
The telephone keeps ringing
and no fax is printed.
RECEPTION/COPYING
No printout; the Add Paper
indicator is lit.
No printout; CLEAR
COPY appears.
Copies appear dirty.
Copies are too light.
Copies are blank.
176
The document is jammed in the feeder.
\ Remove the jammed document (see page 166)
and repeat the transmission procedure.
The document may be longer than the maximum limit (see
page 15).
\ Make sure that none of your originals exceed
this limit.
Do user maintenance, especially rollers [A] and [F] (see page
154).
\ If the same problem still exists after user
maintenance, adjust the auto document
feeder mechanism (see page 167).
The other machine is out of order.
\ Check the error report.
Ask the other party to check their machine
and correct the fault.
The line is busy or noisy.
\ Check that the dial tone is sent out.
Try to retransmit.
There are some bad lines between you and that other
terminal.
\ Store that terminal's number as a Quick Dial
Key or Speed Dial Code.
Then call a service technician. Inform the
nature of the problem and give the Quick Dial
Key or Speed Dial Code that you stored the
number in.
You are in Manual Receive mode.
\ Change to Auto Receive mode (see page 43).
Power is switched off.
\ Switch the power on.
The cassettes are empty.
\ Add paper (see page 146).
The printer has jammed.
\ Clear the jam (see page 168).
Does the original have a gray or colored background?
\ Select the Lighten contrast setting.
Does the original have a low contrast image?
\ Select the Darken contrast setting.
The original must be placed face down in the document feeder
\ Position the original correctly. See page 20.
SOLVING PROBLEMS