Confirm The Proper Brake Configuration; Inspect The Tires And Wheels (Including Lug Nut Torque) - Genie GS-3384 Service Manual

September 2005
REV D
B-7
Confirm the Proper
Brake Configuration
Proper brake configuration is essential to safe
operation and good machine performance.
Hydraulically-released, spring-applied individual
wheel brakes can appear to operate normally when
they are actually not fully operational.
1 Check each drive hub disconnect cap to be
sure it is in the engaged position.
Part No. 82259
B-8
Inspect the Tires and Wheels
(including lug nut torque)
Maintaining the tires and wheels in good
condition is essential to safe operation and good
performance. Tire and/or wheel failure could result
in a machine tip-over. Component damage may
also result if problems are not discovered and
repaired in a timely fashion.
disengaged position
1 Check all tire treads and sidewalls for cuts,
engaged position
2 Check each wheel for damage, bends and
3 Check each lug nut for proper torque. Refer to
Models with air-filled tires:
4 Check pressure in each air-filled tire. Add air as
GS-3384
Section 3 • Scheduled Maintenance Procedures
CHECKLIST B PROCEDURES
Bodily injury hazard. An over-
inflated tire can explode and could
result in death or serious injury.
Tip over hazard. Do not use
temporary flat tire repair products.
The tires on some machines are
foam filled and do not need air
added to them.
cracks, punctures and unusual wear.
cracks.
Section 2, Specifications.
necessary. Refer to Section 2, Specifications.
3 - 25