Change The Fuel Hoses - Gm Models - Genie GS-3384 Service Manual

September 2005
REV B
24 Install the tank return hose.
25 Install the T-fitting with the 2 hoses connected
to it.
26 Fill the tank with hydraulic oil until the level is
within the top 2 inches / 5.1 cm from the top of
the sight gauge. Do not overfill. Refer to Section
2, Specifications.
27 Clean up any oil that may have spilled during
the procedure.
28 If equipped, open the hydraulic tank shutoff
valves.
Component damage hazard.
Be sure to open the two hydraulic
tank shutoff valves and prime the
pump after installing the hydraulic
tank.
Refer to Repair procedure 7-2,
How to Prime the Pump.
29 Install the access plate and install the access
plate retaining fasteners.
30 Install the entry ladder and install the entry
ladder mounting fasteners.
17 Clean up any fuel that may have spilled during
this procedure.
Part No. 82259
Section 3 • Scheduled Maintenance Procedures
CHECKLIST E PROCEDURES
E-2
Change the Fuel Hoses -
GM Models
Maintaining the fuel hoses in good condition is
essential to safe operation and good engine
performance. Failure to detect a worn, cracked or
leaking fuel hose may cause an unsafe operating
condition.
Explosion and fire hazard. Engine
fuels are combustible. Replace the
fuel lines in an open, well-
ventilated area away from heaters,
sparks, flames and lighted
tobacco. Always have an
approved fire extinguisher within
easy reach.
Bodily injury hazard. Fuel may be
expelled under pressure. Wrap a
cloth around fuel hoses to absorb
leaking fuel before disconnecting
them.
Immediately clean up any fuel that
may have spilled during this
procedure.
Perform this procedure with the
engine off.
1 Turn the key switch to ground controls and pull
out the red Emergency Stop buttons to the on
position at both the ground and platform
controls.
2 Start the engine.
3 Raise the platform approximately 18 feet / 5.5 m
from the ground.
GS-3384 3 - 57