Genie GS-3384 Service Manual page 127

September 2005
REV C
How to Adjust the Lift Speed
1 Pull out the red Emergency Stop button to the
on position at the platform controls.
2 Push in the red Emergency Stop button to the
off position at the ground controls.
3 Turn the key switch to ground control.
4 Press and hold both the blue platform up and
yellow platform down buttons. Pull out the red
Emergency Stop button to the on position at the
ground controls.
Result: is showing in the diagnostic
TUNE SPEEDS
display window. The ECM is now in
programming mode.
5 Press the lift function enable button.
6 Use the yellow platform down arrow to scroll to
lift speed.
Result:
MAX LIFT SPEED
diagnostic display window.
7 Press the lift function enable button.
Part No. 82259
is showing in the
a
a
b
c
d
8 Press the yellow platform down button to
decrease the maximum lift speed or press the
blue platform up button to increase the
maximum lift speed. Refer to Section 2,
Specifications.
The performance acheived should
always be within specifications.
9 Press the lift function enable button.
10 Push in the red Emergency Stop button to the
off position at the ground controls.
11 Check the lift speed of the machine. Refer to
Section 2, Specifications.
GS-3384
Section 4 • Repair Procedures
GROUND CONTROLS
diagnostic display
blue platform up button
lift function enable button
yellow platform down button
b
c
d
4 - 43