Genie GS-3384 Service Manual page 179

September 2005
REV A
Fault Code LED
SYSTEM READY Green
01
Red
INTERNAL ECU
FAULT
02
Red
PLATFORM ECU
FAULT
20
Red
CHASSIS START
SW FAULT
21
Red
CHASSIS CHOKE
SW FAULT
22
Red
CHASSIS UP SW
FAULT
23
Red
CHASSIS LIFT SW
FAULT
24
Red
DOWN SW FAULT
25
Red
LEFT TURN SW
FAULT
26
Red
RIGHT TURN SW
FAULT
27
Red
DRIVE ENABLE
SW FLT
28
Red
OFF NEUTRAL
DRIVE JOYSTICK
29
Red
PLATFORM LIFT
SW FAULT
30
Red
OFF NEUTRAL
LIFT JOYSTICK
31
PLATFORM
Red
CHOKE SW
FAULT
32
Red
PLATFORM
START SW FAULT
33
Red
LEFT FRONT
OUTRIG SW FLT
Part No. 82259
Condition
Normal operation
Internal ECM error.
Platform/ECM communication
error.
Engine start button fault at
ground controls.
Starting aid button fault at
ground controls.
Up switch fault at ground
controls.
Platform up/down enable
button fault at ground controls.
Down switch fault at ground
controls.
Left turn switch fault.
Right turn switch fault.
Function enable switch on
joystick is activated when
machine is turned on.
Drive joystick off neutral when
machine is turned on.
Lift enable button fault at the
platform controls.
Up/down switch off neutral.
Starting aid fault at the
platform controls.
Engine start button fault at
platform controls.
Left front outrigger enable
button fault at platform
controls.
Fault Code Chart
(after serial number GS8403-40212)
Result
System shutdown.
System shutdown.
Engine will not start.
Starting aid disabled.
Platform up function inoperable.
Platform up/down functions
disabled.
Platform down function disabled.
Malfunctioning steer left
microswitch.
Malfunctioning steer right
microswitch.
Machine functions disabled.
Machine functions disabled.
Lift function disabled.
Up/down function disabled.
Starting aid disabled.
Engine will not start.
Outriggers disabled.
GS-3384
Section 5 • Fault Codes
Solution
Replace ECM.
Troubleshoot control cable OR
troubleshoot platform controls.
Replace ECM.
Replace ECM.
Replace ECM.
Replace ECM.
Replace ECM.
Troubleshoot steer left microswitch.
Troubleshoot steer right microswitch.
Release function enable switch on
joystick before power up OR replace
joystick.
Release joystick before power up OR
replace joystick.
Troubleshoot button OR replace printed
circuit board at platform controls.
Replace up/down switch at platform
controls.
Troubleshoot button OR replace printed
circuit board at platform controls.
Troubleshoot button OR replace printed
circuit board at platform controls.
Troubleshoot button OR replace printed
circuit board at platform controls.
5 - 5