Genie GS-3384 Service Manual page 80

Section 3 • Scheduled Maintenance Procedures
CHECKLIST E PROCEDURES
9 If equipped, close the two hydraulic shutoff
valves located at the hydraulic tank.
Component damage hazard. The
engine must not be started with
the hydraulic tank shutoff valves in
the closed position or component
damage will occur. If the tank
valves are closed, remove the key
from the key switch and tag the
machine to inform personnel of the
condition.
open
10 Remove the drain plug from the hydraulic tank
and completely drain the tank into a suitable
container. See capacity specifications.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to squirt
or spray.
Bodily injury hazard. Beware of
hot engine parts and oil. Contact
with hot oil and/or hot engine parts
may cause severe burns.
11 Tag, disconnect and plug the two suction hoses
that are attached to the hydraulic tank
shutoff valves or tank.
3 - 56
12 Tag, disconnect and plug the tank return hose
13 Tag, disconnect and plug the T-fitting located at
14 Remove the hydraulic tank strap retaining
15 Support and secure the hydraulic tank to a
16 Remove the hydraulic tank from the machine.
17 If equipped, remove the suction strainers from
closed
18 Rinse out the inside of the tank using a mild
19 If equipped, install the suction strainers using
20 Install the drain plug using Loctite® 567 on the
21 Install the hydraulic tank onto the machine.
22 Install the hydraulic tank strap.
23 Install the two suction hoses.
GS-3384
at the tank.
the tank with the 2 hoses connected to it.
fasteners and remove the hydraulic tank strap
from the machine.
suitable lifting device.
Crushing hazard. The hydraulic
tank could become unbalanced
and fall if it is not properly
supported and secured to the
lifting device when it is removed
from the machine.
the tank and clean them using a mild solvent.
solvent.
Loctite® 567 on the pipe threads.
Always use Loctite® 567 on all
pipe threads.
pipe threads.
Always use Loctite® 567 on all
pipe threads.
September 2005
REV B
Part No. 82259