Platform Extension Deck - Genie GS-3384 Service Manual

September 2005
REV B
2-2

Platform Extension Deck

How to Remove a Platform
Extension Deck
Perform this procedure with the
platform in the stowed position
and the platform extension deck(s)
fully retracted and locked in
position.
If the machine is equipped with the
dual extension deck option, repeat
this procedure for the other
platform extension deck.
1 Steer end extension deck: Remove the
platform controls from the platform and lay them
off to the side of the machine.
2 Remove the retaining pins from the four black
plastic railing guides. Lower the railing guides in
the down direction.
3 Remove the mounting fasteners from the
platform extension deck stop brackets at both
sides of the deck.
The platform extension deck stop
brackets are located above the
platform V-roller wheels.
4 At the platform extension deck to be removed,
position a fork lift with the forks even with the
bottom of the platform extension deck.
5 Lift the platform extension deck lock handle.
Part No. 82259
6 Carefully slide the platform extension deck out
until the platform extension deck makes contact
with the carriage on the forklift.
7 Attach a strap from the platform extension deck
railings to the carriage on the forklift to help
support the platform extension deck.
8 Remove the three V-roller and extension deck
lock bracket mounting fasteners from the
extension deck at the tank side of the machine.
9 Carefully pull the V-roller and extension deck
lock assembly out of the extension deck.
10 Remove the fasteners from the roller wheels
located under the platform extension deck.
Remove the roller wheels.
11 Carefully slide the platform extension deck out
of the platform and place it on a structure
capable of supporting it.
Crushing hazard. The platform
extension deck could become
unbalanced and fall when
removed from the machine if not
properly supported and secured to
the forklift.
GS-3384
Section 4 • Repair Procedures
PLATFORM COMPONENTS
4 - 17