Genie GS-3384 Service Manual page 122

Section 4 • Repair Procedures
GROUND CONTROLS
Models with software revision C0 or higher:
1 Pull out the red Emergency Stop button to the
on position at the platform controls.
2 Push in the red Emergency Stop button to the
off position at the ground controls.
3 Turn the key switch to ground control.
4 Press and hold both the blue platform up and
yellow platform down buttons. Pull out the red
Emergency Stop button to the on position at the
ground controls.
Result: is showing in the diagnostic
TUNE SPEEDS
display window. The ECM is now in
programming mode.
5 Press the lift function enable button.
6 Use the yellow platform down arrow to scroll to
max fwd high speed drive.
Result:
MAX FWD HIGH SPEED DRIVE
the diagnostic display window.
7 Press the lift function enable button.
8 Press the yellow platform down button to
decrease the drive speed or press the blue
platform up button to increase the drive speed.
Refer to Section 2, Specifications.
The performance achieved should
always be within specifications.
9 Press the lift function enable button.
Result: is showing in the diagnostic
TUNE SPEEDS
display window. The ECM is now in
programming mode.
4 - 38
a
10 Press the lift function enable button.
11 Use the yellow platform down arrow to scroll to
12 Press the lift function enable button.
13 Press the yellow platform down button to
is showing in
14 Press the lift function enable button.
15 Push in the red Emergency Stop button to the
16 Check the stowed drive speed of the machine.
GS-3384
a diagnostic display
b blue platform up button
c lift function enable button
d yellow platform down button
max rev high speed drive.
Result:
MAX REV HIGH SPEED DRIVE
the diagnostic display window.
decrease the drive speed or press the blue
platform up button to increase the drive speed.
Refer to Section 2, Specifications.
The performance achieved should
always be within specifications.
off position at the ground controls.
Refer to the Maintenance procedure B-15, Test
the Drive Speed - Stowed Position.
September 2005
REV C
b
c
d
is showing in
Part No. 82259