September 2005
REV C
How to Adjust the Platform
Settling Speed
1 Pull out the red Emergency Stop button to the
on position at the platform controls.
2 Push in the red Emergency Stop button to the
off position at the ground controls.
3 Turn the key switch to ground control.
4 Press and hold both the blue platform up and
yellow platform down buttons. Pull out the red
Emergency Stop button to the on position at the
ground controls.
Result:
is showing in the diagnostic
TUNE SPEEDS
display window. The ECM is now in
programming mode.
5 Press the lift function enable button.
6 Use the yellow platform down arrow to scroll to
settling speed.
Result:
MAX SETTLING SPEED
diagnostic display window.
Part No. 82259
is showing in the
GS-3384
Section 4 • Repair Procedures
a
a
diagnostic display
b
blue platform up button
c
lift function enable button
d
yellow platform down button
7 Press the lift function enable button.
8 Press the yellow platform down button to
decrease the platform settling speed or press
the blue platform up button to increase the
platform settling speed.
Component Damage Hazard. The
Platform Settling Speed is
intended to slow the rate of
platform descent just before the
reaching the stowed position.
Adjust the Platform Settling Speed
until the Platform Settling Speed
percentage is 3 to 5 points less
than the Platform Lowering
Speed percentage.
9 Press the lift function enable button.
10 Push in the red Emergency Stop button to the
off position at the ground controls.
GROUND CONTROLS
b
c
d
4 - 45