Genie GS-3384 Service Manual page 94

Section 4 • Repair Procedures
PLATFORM CONTROLS
How to Adjust the Steer Speed
The steering speed is not
adjustable on machines with
software revision B. See 1-3, How
to Determine the Revision Level.
1 Remove the platform controls from the platform
and place the controls near the diagnostic
display at the ground control panel.
2 Turn the key switch to the off position.
3 Models without outriggers: Press and hold
the horn button and platform extend/retract
enable button, then turn the key switch to
platform control.
Models with outriggers: Press and hold the
horn button and the outrigger enable button,
then turn the key switch to platform control.
®
Stop
d
c
b
STOP
c
d b
a steering rocker switch SW6
b horn button BN5
c machine on incline button BN6
OR machine on incline/LF outrigger
button BN17
d platform extend/retract enable BN16
OR outrigger enable button BN16
4 - 10
a
®
Stop
AUTO
LEVEL
a
STOP
GS-3384
4 The fault-code display window at the ground
controls will show "PS". When you see this
code, release the horn button and the platform
extend/retract enable button or outrigger enable
button.
The "PS" in the fault code display
window indicates that the ECM is
in the programming mode.
5 Press and hold the machine on incline button to
show the steering speed percentage in the
fault-code display window.
6 To increase or decrease the steering speed,
press and hold the machine on incline button
while using the steering rocker switch to adjust
the function speed. Refer to Section 2,
Specifications.
7 Release the machine on incline button.
8 Turn the key switch to the off position to save
the settings.
September 2005
REV C
Part No. 82259