Check The Engine Fasteners - Gm Models; Perform 30 Day Service - Genie GS-3384 Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
A-9
Check the Engine Fasteners -
GM Models
Engine specifications require that
this one-time procedure be
performed after the first 40 hours
of engine operation.
Properly torqued engine fasteners are essential to
good engine performance and operational safety.
Loose or improperly torqued fasteners can result in
engine component damage and hazardous
conditions.
Bodily injury hazard. Do not
inspect while the engine is
running. Remove the key to
secure from operation.
Burn hazard. Beware of hot
engine components. Contact with
hot engine components may
cause severe burns.
1 Release the latches on the engine tray and fully
slide the engine tray out.
2 Insert a 6 inch / 15 cm screwdriver or rod into
the engine tray lock hole, located near the
engine tray roller wheels, to prevent the engine
tray from moving.
3 Tighten all intake manifold retaining fasteners.
Torque to 16 to 19 ft-lbs / 22 to 26 Nm.
4 Tighten all exhaust manifold retaining fasteners.
Torque to 16 to 19 ft-lbs / 22 to 26 Nm.
5 Tighten all alternator mounting fasteners.
Torque to 16 to 19 ft-lbs / 22 to 26 Nm.
6 Tighten all engine starter mounting fasteners.
Torque to 16 to 19 ft-lbs / 22 to 26 Nm.
7 Tighten all fan retaining fasteners.
Torque to 16 to 19 ft-lbs / 22 to 26 Nm.
3 - 12
A-10

Perform 30 Day Service

The 30 day maintenance procedure is a one-time
sequence of procedures to be performed after the
first 30 days or 40 hours of usage. After this
interval, refer to the maintenance checklists for
continued scheduled maintenance.
1 Perform the following maintenance procedures:
GM models:
· B-8 Inspect the Tires and Wheels
(including lug nut torque)
· D-6 Replace the Hydraulic Tank
Return Filter
Ford models:
· B-8 Inspect the Tires and Wheels
(including lug nut torque)
· B-21 Perform Engine Maintenance -
Ford Models
· D-6 Replace the Hydraulic Tank
Return Filter
Deutz models:
· B-6 Check and Adjust the Engine RPM
· B-8 Inspect the Tires and Wheels
(including lug nut torque)
· D-4 Replace the Fuel Filter/Water
Separator - Deutz Models
· D-6 Replace the Hydraulic Tank
Return Filter
Deutz 1011F models:
· C-3 Perform Engine Maintenance -
Deutz Models
GS-3384
September 2005
REV C
Part No. 82259