Genie GS-3384 Service Manual page 48

Section 3 • Scheduled Maintenance Procedures
CHECKLIST B PROCEDURES
a
f solenoid boot
Deutz models with throttle cable
a low idle adjustment lock nut
b high idle adjustment lock nuts
c cable sheath
6 Before serial number GS8403-40213: Move
the rpm select toggle switch to the high idle
(rabbit symbol) position.
After serial number GS8403-40212: Press the
high idle (rabbit symbol) button.
7 Before serial number GS8403-40213: Move
and hold the start toggle switch to the start
position and check the engine RPM on the
diagnostic display. Refer to Section 2,
Specifications.
After serial number GS8403-40212: Press
and hold the start button and check the engine
RPM on the diagnostic display. Refer to Section
2, Specifications.
Skip to step 11 if the high idle rpm is correct.
If the high idle rpm is not correct and the low
idle was just calibrated, proceed to step 10. All
other machines, open the engine tray. Proceed
to step 8.
3 - 24
c
b b
GS-3384
8 Release the latches on the engine tray and fully
slide the engine tray out.
9 Insert a 6 inch / 15 cm screwdriver or rod into
the engine tray lock hole located near the
engine tray roller wheels to prevent the engine
tray from moving.
10 Models with throttle cable: Loosen the lock
nut on the high idle solenoid. Turn the
adjustment nut clockwise to increase the rpm or
counter clockwise to decrease the rpm. Tighten
the lock nut and confirm the rpm.
Models with throttle linkage: Loosen the yoke
lock nut, then turn the high idle adjustment nut
and solenoid boot counterclockwise to increase
the rpm or clockwise to decrease the rpm.
Tighten the yoke lock nut and confirm the rpm.
Be sure the solenoid fully retracts
when activating high idle.
a
Deutz models with throttle cable
a high idle solenoid
b adjustment nut
c lock nut
d cable sheath
11 Close and latch the engine slide out tray.
September 2005
REV D
c
b d
Part No. 82259