Genie GS-3384 Service Manual page 130

Section 4 • Repair Procedures
GROUND CONTROLS
How to Adjust the Steer Speed
1 Pull out the red Emergency Stop button to the
on position at the platform controls.
2 Push in the red Emergency Stop button to the
off position at the ground controls.
3 Turn the key switch to ground control.
4 Press and hold both the blue platform up and
yellow platform down buttons. Pull out the red
Emergency Stop button to the on position at the
ground controls.
Result: is showing in the diagnostic
TUNE SPEEDS
display window. The ECM is now in
programming mode.
5 Press the lift function enable button.
6 Use the yellow platform down arrow to scroll to
steering speed.
Result:
STEERING SPEED
diagnostic display window.
4 - 46
is showing in the
a
a
b
c
d
7 Press the lift function enable button.
8 Press the yellow platform down button to
decrease the steering speed or press the blue
platform up button to increase the steering
speed.
9 Press the lift function enable button.
10 Push in the red Emergency Stop button to the
off position at the ground controls.
GS-3384
September 2005
diagnostic display
blue platform up button
lift function enable button
yellow platform down button
Part No. 82259
REV C
b
c
d