Software Configuration (After Serial Number Gs8403-40212) - Genie GS-3384 Service Manual

September 2005
REV C
5-3
Software Configuration
(after serial number GS8403-40212)
How to Configure the Software
The Electronic Control Module (ECM) contains
programming for all configurations of the GS-84.
Models after serial number GS8403-40212 can be
adjusted to a different configuration using the
buttons at the ground controls.
ANSI and CSA models:
1 Pull out the red Emergency Stop button to the
on position at the platform controls.
2 Push in the red Emergency Stop button to the
off position at the ground controls.
3 Turn the key switch to ground control.
4 Press and hold both the blue platform up and
yellow platform down buttons. Pull out the red
Emergency Stop button to the on position at the
ground controls.
Result: is showing in the diagnostic
TUNE SPEEDS
display window.
a
a diagnostic display
b blue platform up button
c lift function enable button
d yellow platform down button
Part No. 82259
Machine Option Definitions
Descent Delay: This option halts descent at
approximately 12 feet / 3.6 m. All controls must
be released for 4 to 6 seconds before descent
is re-enabled. Required for Europe.
Lift/Drive Cut Out: Lift and drive functions are
disabled when the down limit switch is activated
and the machine is on a slope exceeding the
rating on the serial plate. Activated for all
machines.
Motion Alarm: The motion alarm will sound
when activating a function.
Motion Beacons: The flashing beacons
operate only when activating a function.
Overload: This cuts out all functions when the
platform overload pressure switch is tripped.
The red Emergency Stop button must be cycled
before any function can be resumed. Required
for Europe.
Sim Operation: When enabled, this allows
some machine functions to be activated
simultaneously. Required to be disabled for
European models.
Beacons: When installed on the machine, the
b
flashing beacons operate continuously when
the key switch is to ground or platform controls
c
and both red Emergency Stop buttons are in
the on position.
d
GS-3384
Section 4 • Repair Procedures
GROUND CONTROLS
4 - 47