Genie GS-3384 Service Manual page 115

September 2005
REV C
How to Install the Flex Plate
1 Install the flex plate onto the engine flywheel
with the raised spline towards the pump. Install
the mounting bolts and tighten to finger tight.
2 Ford and GM models: Torque the flex plate
mounting bolts in sequence to 14 ft-lbs / 19 Nm.
Deutz models: Torque the flex plate mounting
bolts in sequence to 28 ft-lbs / 38 Nm.
3 Ford and GM models: Torque the flex plate
mounting bolts in sequence to 20 ft-lbs / 27 Nm.
Deutz models: Torque the flex plate mounting
bolts in sequence to 40 ft-lbs / 54 Nm.
6
4
Flex plate bolt torque sequence
Part No. 82259
1
3
5
2
4 Install the pump coupler onto the pump shaft
with the set screw toward the pump. Leave the
appropriate gap between coupler and pump
end plate for your engine.
a
b
c
d
e
f
5 Apply Loctite ®
pump coupler set screw. Torque the set screw
to 61 ft-lbs / 83 Nm.
GS-3384
Section 4 • Repair Procedures
a b c d
f
pump
pump shaft
pump coupler
flex plate with raised spline
engine flywheel
7
/ inch / 11 mm gap
16
removable thread sealant to the
ENGINES
e
4 - 31