Genie GS-3384 Service Manual page 181

September 2005
REV A
Fault Code LED
66
Red
LOW OIL
PRESSURE
67
Red
HIGH COOLANT
TEMPERATURE
68
Red
LOW ECU
VOLTAGE
69
Red
LOW ENGINE
RPM
70
Red
HIGH ENGINE
RPM
80
Red
LEFT FRONT
OTRG COIL FLT
81
Red
LEFT REAR OTRG
COIL FLT
82
Red
RIGHT FRONT
OTRG COIL FLT
83
Red
RIGHT REAR
OTRG COIL FLT
84
Red
OUTRIGGER EXT
COIL FLT
85
Red
OUTRIGGER RET
COIL FLT
86
Red
OUTRIGGER
SLOW COIL FLT
90
Red
2 SPEED COIL
FAULT
92
Red
DRIVE FWD PROP
COIL FAULT
93
Red
DRIVE REV PROP
COIL FAULT
94
Red
MACHINE TYPE
FAULT
Part No. 82259
Condition
Low oil pressure.
High coolant temperature.
Low ECM voltage.
Low RPM.
High RPM.
Left front outrigger coil (Y35)
fault.
Left rear outrigger coil (Y33)
fault.
Right front outrigger coil (Y36)
fault.
Right rear outrigger coil (Y34)
fault.
Outrigger extend coil (Y40)
fault.
Outrigger retract coil (Y39)
fault.
Outrigger slowdown coil (Y44)
fault.
2 speed coil (Y1) fault
Drive pump forward
proportional coil (Y51) fault
Drive pump reverse
proportional coil (Y51) fault
Wrong machine type selected
(AFTER SERIAL NUMBER GS8403-40212)
Result
Engine stops.
High engine temperature OR
defective engine coolant or oil
temperature switch.
System shutdown.
Engine idle RPM too low.
Engine RPM too high.
Left front outrigger disabled.
Left rear outrigger disabled.
Right front outrigger disabled.
Right rear outrigger disabled.
Outrigger extend function disabled.
Outrigger retract function disabled.
Outrigger slow extend function
disabled.
High torque drive function disabled.
Drive forward function disabled.
Drive reverse function disabled.
Machine will not operate.
GS-3384
Section 5 • Fault Codes
FAULT CODE CHART
Solution
Check the engine oil level OR check
wiring from the oil pressure switch to
ECM
OR replace the oil pressure switch.
Gasoline/LPG models: Check the
engine radiator coolant level OR check
the wiring from the water temperature
switch to ECM OR replace the water
temperature switch.
Diesel models: Check the engine oil
level OR check the wiring from the oil
temperature switch to ECM OR replace
the oil temperature switch.
Charge battery.
Consult Genie Industries Service
Department.
Consult Genie Industries Service
Department.
Troubleshoot coil OR wiring.
Troubleshoot coil OR wiring.
Troubleshoot coil OR wiring.
Troubleshoot coil OR wiring.
Troubleshoot coil OR wiring.
Troubleshoot coil OR wiring.
Troubleshoot coil OR wiring.
Troubleshoot coil OR wiring.
Troubleshoot coil OR wiring.
Troubleshoot coil OR wiring.
Correct selection.
5 - 7