Performance Specifications; Hydraulic Specifications - Genie GS-3384 Service Manual

Section 2 • Specifications
SPECIFICATIONS

Performance Specifications

Drive speed, maximum
Platform stowed
Platform raised
Gradeability
Rated work load at full height, maximum
GS-3384
Function speed, maximum from platform controls
(with maximum rated load in platform)
GS-3384
Platform up
Platform down
Airborne noise emissions
Maximum sound level at normal operation workstations
(A-weighted)
Continuous improvement of our products is a
Genie policy. Product specifications are
subject to change without notice.
2 - 2

Hydraulic Specifications

Hydraulic Oil Specifications
4 mph Before serial number 40085
40 ft / 6.8 sec Hydraulic oil type
6.4 km/h
After serial number 40084
12.2 m / 6.8 sec
Hydraulic oil type
0.7 mph ISO viscosity grade
40 ft / 39 sec Viscosity index
1.1 km/h
Cleanliness level, minimum
12.2 m / 39 sec
Water content, maximum
50%
Chevron Rykon MV oil is fully compatible and
mixable with Shell Donax TG (Dexron III) oils.
2500 lbs Genie specifications require hydraulic oils which are
1135 kg designed to give maximum protection to hydraulic
systems, have the ability to perform over a wide
temperature range, and have a minimum viscosity index
rating of 150. They should provide excellent antiwear,
oxidation, corrosion inhibition, seal conditioning, and
foam and aeration suppression properties.
42 to 52 seconds
Optional fluids
25 to 35 seconds
Biodegradable
80 dB
Fire resistant
Mineral based
GS-3384
September 2005
Shell Donax TG (Dexron III)
Chevron Rykon MV equivalent
Multi-viscosity
Petro Canada Premium ECO 46
Statoil Hydra Way Bio Pa 32
BP Biohyd SE-S
UCON Hydrolube HP-5046
Quintolubric 822
Shell Tellus T32
Shell Tellus T46
Chevron Aviation A
Use Chevron Aviation A hydraulic
oil when in ambient temperatures
consistently below 0°F / -17°C.
Use Shell Tellus T46 hydraulic oil
when oil temperatures consistently
exceed 205°F / 96°C.
Genie specifications require
additional equipment and special
installation instructions for the
approved optional fluids. Consult
the Genie Industries Service
Department before use.
Part No. 82259
REV C
200
15/13
200 ppm