Replace The Fuel Filter - Gm Models - Genie GS-3384 Service Manual

September 2005
REV D
B-22
Replace the Fuel Filter -
GM Models
Engine specifications require that
this procedure be performed every
400 hours of operation.
Replacing the gasoline fuel filter is essential to
good engine performance and service life. A dirty
or clogged filter may cause the engine to perform
poorly and continued use may cause component
damage. Extremely dirty conditions may require
that the filter be replaced more often.
Explosion and fire hazard. Engine
fuels are combustible. Replace the
fuel filter in an open, well-
ventilated area away from heaters,
sparks, flames and lighted
tobacco. Always have an
approved fire extinguisher within
easy reach.
Perform this procedure with the
engine off.
1 Remove the retaining fasteners from the fuel
pump mounting plate located under the
hydraulic and fuel tank tray.
2 Carefully lower the fuel pump mounting plate.
3 Turn the manual shutoff valves, located at the
fuel tank, to the
CLOSED
Part No. 82259
position.
GS-3384
Section 3 • Scheduled Maintenance Procedures
CHECKLIST B PROCEDURES
4 At the fuel filter, tag, disconnect and plug the
fuel hose from the fuel tank.
Component damage hazard.
Hoses can be damaged if they are
kinked or pinched.
5 At the fuel filter, tag, disconnect and plug the
fuel hose from the fuel filter to the fuel pump.
Remove and properly discard the filter.
6 Install the fuel hoses onto the new fuel filter and
tighten the clamps. Do not over tighten.
Be sure the arrow on the filter,
which indicates flow direction, is
pointing towards the fuel pump.
7 Clean up any fuel that may have spilled during
the installation procedure.
8 Turn the manual shutoff valves, located at the
fuel tank, to the
OPEN
9 Clean up any fuel that may have spilled during
this procedure.
10 Start the machine from the ground controls and
inspect the fuel filters and hoses for leaks.
Explosion and fire hazard. If a fuel
leak is discovered, keep any
additional personnel from entering
the area and do not operate the
machine. Repair the leak
immediately.
11 Install the fuel pump mounting plate under the
fuel and hydraulic tank tray and tighten the
mounting fasteners.
position.
3 - 35