Genie GS-3384 Service Manual page 114

Section 4 • Repair Procedures
ENGINES
15 Attach a lifting strap from an overhead crane to
the pump and bell housing assembly for
support. Do not apply any lifting pressure.
16 Remove all of the bell housing to engine
fasteners.
17 Carefully pull the pump and bell housing away
from the engine and secure it from moving.
Component damage hazard.
Hoses can be damaged if they are
kinked or pinched.
18 Remove the flex plate mounting fasteners.
Remove the flex plate from the flywheel.
4 - 30
Deutz models:
1 Release the latches on the engine tray and fully
slide the engine tray out.
2 Insert a 6 inch / 15 cm screwdriver or rod into
the engine tray lock hole located near the
engine tray roller wheels to prevent the engine
tray from moving.
3 Remove the hose clamp from the air cleaner
hose that connects to the engine.
4 Remove the air filter mounting fasteners.
Remove the air filter from the engine and lay it
off to the side.
5 Remove the exhaust pipe clamp from the
exhaust pipe support bracket.
6 Attach a lifting strap from an overhead crane to
the pump assembly for support. Do not lift it.
7 Remove all of the pump mounting plate to
engine fasteners.
8 Carefully pull the pump assembly away from the
engine and secure it from moving.
Component damage hazard.
Hoses can be damaged if they are
kinked or pinched.
9 Remove the flex plate mounting fasteners.
Remove the flex plate from the flywheel.
GS-3384
September 2005
REV C
Part No. 82259