Enable Reset Of Interlocks In Manual Mode - Siemens SIMOCODE pro Programming And Operating Manual

Description of the blocks
4.1 Functions for all blocks
Set reset depending on the LiOp parameter (counter blocks)
This feature bit can also be used to determine whether the setting or resetting to a default
value should be made dependent on the
The default setting is 0.
Bit = 0: Setting or resetting to a default value does not depend on the
Bit = 1: Setting or resetting to a default value depends on the
LiOp
parameter for the faceplate.
LiOp
interconnections.
4.1.10.23

Enable reset of interlocks in manual mode

Number of the
Feature
Feature bit purpose
Specify whether a reset is necessary once the "Protection" interlock signal, feedback errors
("Runtime error", "Control deviation"), or "Motor protection" are present again. See also the
following section, 'Resetting the block in case of interlocks or errors' (Page 84).
The default setting is 0.
Bit = 0: No reset required in manual mode.
Bit = 1: Reset required in manual mode. The reset is performed using the "Reset" button
(
RstOp = 1
Note
Rapid stop is unlocked for all operating modes using the "Reset" button in the faceplate
(
RstOp = 1
Note
The local operating mode has a separate reset mechanism.
90
= 0: Setting or resetting to a default value can only be made via the faceplate or at the
= 1: Setting or resetting to a default value can only be made at the parameter for
bit: 31
) or, in CFC, using the input parameter
); in CFC it is unlocked using the
parameter.
LiOp
RstLi
= 1 input parameter.
RstLi
Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
parameter.
LiOp
parameter.
LiOp
.
SIMOCODE pro PCS 7 Library V9.0