Siemens SIMOCODE pro Programming And Operating Manual page 168

Description of the blocks
4.4 Block for MMMeas measured value function
Figure 4-5
Voltage values
①
Voltage values UL1-UL3 as bars (Vol_OpScale high value, low value)
②
Phase voltage in Volts (MotVol1, MotVol2, MotVol3)
③ Active power in watts (ActPower)
④
Apparent power in VA (AppPower)
⑤
Power factor Cos phi in % (MotCosPhi)
⑥
Last successfull Timestamp of Read Data
⑦ Button for updating the data (RdDataOp).
Button is deactivated if RackF_Act = 1, authorization level 5 and higher (ProcessControling)
These parameters are enabled when a Voltage measuring module is connected.
Note
In case of line voltage, UL1-L2, UL2-L3, UL3-L1 will be displayed.
168
Voltage module
Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
SIMOCODE pro PCS 7 Library V9.0