Message Characteristics - Siemens SIMOCODE pro Programming And Operating Manual

4.4.5

Message characteristics

MMMeas reports the following errors at the block output:
● Rack fault (
● Module fault (
An error generates a group error
These errors are not signaled as alarms as they are already part of the MMDiag block (both
on the DP master system and behind the Y-Link/ IE-PB-Link). The alarms are output using
the ALARM_8P function.
The messages can be enabled or disabled using the
The alarms are also suppressed if the block is in Out of service mode.
The alarms are suppressed on warm restart for the number of cycles set for power up in the
RunUpCyc
Message block MsgEvId1
Table 4- 69 Output messages
Message block Message No.
MsgEvId1
1
2
3
4
5
6
7
8
* S = AS, OS process control fault
** User-definable message
SIMOCODE pro PCS 7 Library V9.0
Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
)
RackF_Act
)
ModF_Act
parameter.
Block parameters
**
ExtMsg1
**
ExtMsg2
**
ExtMsg3
**
ExtMsg4
**
ExtMsg5
**
ExtMsg6
**
ExtMsg7
**
ExtMsg8
4.4 Block for MMMeas measured value function
in output parameter
GrpErr
MsgLock
Message text
$$BlockComment$$External Message 1
$$BlockComment$$External message 2
$$BlockComment$$External message 3
$$BlockComment$$External message 4
$$BlockComment$$External message 5
$$BlockComment$$External message 6
$$BlockComment$$External message 7
$$BlockComment$$External message 8
Description of the blocks
.
Err_Act
input.
Message
class *
S
S
S
S
S
S
S
S
161